Marshall1973

Thursday, 16 May 2013

Sucka (Pt 1)

Posted by Ben Liddell at 13:14
Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest

No comments:

Post a Comment

Newer Post Older Post Home
Subscribe to: Post Comments (Atom)

Blog Archive

  • ▼  2013 (55)
    • ►  June (10)
    • ▼  May (45)
      • Power up
      • Testing - Continuity point-to-point
      • Testing - Continuity / Non-continuity
      • Still on the line (II)
      • Still on the line
      • Wiring in the turret board (pots and ground bus)
      • Wiring in the turret board (valve holders)
      • The Cable Tie
      • That sinking feeling
      • Tickling round the edges
      • Output Transformer Primaries - doing the math(s)
      • How to twist wire properly
      • Greenback (part two)
      • Greenback (part one)
      • Rectification
      • Completed turret board wiring
      • Tinning
      • Sucka (Pt 2)
      • Sucka (Pt 1)
      • Pliers, strippers and snippers
      • Wiring the Power Transformer (Big Iron Part V)
      • 1973 Master Reverb 18w Combo
      • How a valve is made
      • Normal channel shielded input wiring
      • Power Transformer Wiring (Big Iron Part IV)
      • That shrinking feeling
      • Big Iron (Part III)
      • Input jacks
      • Big Iron (Part II)
      • Big Iron (Part I)
      • Turret board with some wiring
      • Power resistors
      • Missing components
      • Heater wiring disaster
      • Twisting wire
      • PTFE wire
      • Initial turret board soldering
      • My SE-5a 5W build
      • Resistors on turret board
      • The plan
      • Sorting
      • The Ground Bus
      • Soddering
      • The kit
      • My 18w amp build

About Me

My photo
Ben Liddell
View my complete profile
Simple theme. Powered by Blogger.